RB iconIP iconMPE iconRBAS iconRouse icon
FavoriteFavorito
shareCompartir
Save searchGuardar búsqueda
Imprimir

INFORMACIÓN

Grupo de productos
Otros equipos de perforación
Marca / modelo
Nemek 300TSE
Año de fabricación
1999
Ubicación
Buskerud
País
Noruega
Mascus ID
11DB598E

PRECIO

Seleccione una moneda

DETALLES

Referencia
17110
Más información
Please provide reference number upon request: 17110 Specifications: - Engine: Deutz air-cooled - Kw: 49 - Weight: 7500kg - Hours: There is no hour meter on the machine, so it is uncertain. - In 2021, a lot of hydraulic hoses were changed. - Engine oil, filter, hyd. filter, diesel filter and air filter as well as oil on track gears and rotary gearbox have recently been changed. - Feed length for 3m lining pipes - Board up to 220mm - Cavotec radio control - Top winch 750kg - Rear mounted winch - Near stop cord on mast - Telescopic magazine for drill pipes above the left belt (120m) - Dynaset welding device - Dynaset water pump - Has been driven with a top hammer/Drifter by Tautech - Went with clamping table instead of key table at Tautech (Possibly still available at Qmatec if it is of interest) Description: Light and clever rig that works as it should, even if it is getting a few years old. Very good technical condition. This is one of the last 300 models built at Nemek Strong mast on this, the same as was used on the 510TS. Tautech rebuilt this machine from hydraulic levers to radio control, supplied by Cavotec. This is a rig for drilling casings and rock holes with a DTH hammer. It's an air-powered hammer, you have to have a large air compressor with you in addition to this. This is for drilling water wells or light foundations of smaller dimensions. It does not come with either a compressor, drill hammers, drill strings or air hoses. Mostrar más

ATS Norway AS

Industriveien 43B 7080 Heimdal Trøndelag Noruega
6
Años en Mascus
report adReportar anuncio sospechoso